ORTUR Obsidian 3D Drucker Firmware
Hier hat man die Möglichkeit die aktuellste Firmware für den ORTUR Obsidian fertig zum Flashen herunterzuladen.
Firmware :
OPF_OBS_Marlin_2_0_7_2_20201228.zip
- Enable BABYSTEP_ZPROBE_OFFSET // Combine M851 Z and Babystepping
OPF_OBS_V62_MARLIN_20201018.zip
- Modified the control interface of the power module
- Optimize power outage detection and Power loss recovery
- Optimize automatic leveling process.
- Add probe Z-Offset automatic detection.
- Fix long click failure problem on touch screen
- Add Touch calibration menu
- Add interference filter for filament runout detection
- Diese Firmware hat eine neue GUI
Ortur_Obsidian_V62_Firmware_update_file_20201018.zip
- Optimized unnecessary interface performance waste.
- The auto-leveling screen has been added with a message box asking if z-Offset needs to be automatically detected
- Add a screensaver to the screen during printing. Increase the life of the screen and avoid white screen failure.
- Fixed an issue where you couldn't adjust the brightness of the light.
Ortur_Obsidian_V62_Firmware_update_file_20201016_FanHalfSpeed.zip
- Fixed a problem where the fan could only rotate at 100% speed.
- Fixed an issue where heating may fail at 110 degrees in winter.
- Optimize the automatic leveling process, and let the machine automatically detect the Z-OFFSET value.
- Fixed an issue where heating might stop during printing.
Ortur_Obsidian_V62_Firmware_update_file_20201010.zip
Ortur_Obsidian_V61_Firmware_update_file_20200910.zip
Zurück
|